And if that isn't enough an aluminium cover plate and or suitable
bottom doubler can be used, or so I am told.
ST
On Thu, Feb 11, 2010 at 7:43 PM, Leon Heller <leon355@...> wrote:
> On 11/02/2010 18:29, AnnonC wrote:
>> I'm looking for a method to deburr my ground vias to smooth the drill hole for copper plating. I do RF prototypes and the PCB has a lot of ground vias. In the past, I used 2 pass drill to drill the hole, the 2nd pass, one 1 mill smaller but it doesn't seem to help much. I can increase the diameter of the via hole up to 50 mils.
>
> Use sharp drills at the proper speed.
>
> Leon
>