Ok, guys
You got me, it was late. Of course it's 200x160mm not cm or in other
words ~8" x 6.4". Sorry :))
Dave, nice link. The X/Y table you refer to could of course be used,
but it's way overkill for what I have in mind.
I figure it's best if I shut up now a bit until something comes to
live and then present a link or such - or otherwise my boards will
grow again... :))
Markus
>Hi Guys,
>
>I was thinking about the CNC portion for a bit and although I never
>approach a 2 meter by 2.5 meter board like Markus, I think a smaller
>version might be easier to start off with.
>
>
>A small X/Y table is crying out for steppers. 8" x 5" work
>envelope. that is way bigger than my boards. And, it would be easy
>to put under the simple drilling jigs already talked about.
>
>http://www.useenco.com/
>
>part number 201-2826
>
>half way down the page on the left.
>
>Dave
>
>
>
>
>Be sure to visit the group home and check for new Bookmarks and files:
>http://groups.yahoo.com/group/Homebrew_PCBs
>
>To unsubscribe from this group, send an email to:
>Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>