Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] Re: non-plated-through holes with Eagle

From: Brian Lalor <blalor@...>
Date: 2010-01-21

On Jan 20, 2010, at 2:33 PM, Stefan Trethan wrote:

> There's a list 'specially for Eagle, you might have more luck here:
> eaglecad@yahoogroups.com

I joined that list, and one of the first posts I saw was yours on this
topic! :-) I’ll be looking forward to seeing if anyone comes up with
an answer. I searched the archives there briefly and did see a post
from ’08 where someone seemed to be asking a similar question without
a very positive response. It’s not a massive problem, but it would be
nice not to have to think about it…

Brian

--
Brian Lalor / blalor@...
Humanity is rife with enterprising idiots whose final words may
well have
been "hold my beer and watch this."