Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] Re: non-plated-through holes with Eagle

From: Leon Heller <leon355@...>
Date: 2010-01-20

On 20/01/2010 21:07, Stefan Trethan wrote:
> I don't think that would actually do it in this case.
>
> What is required is to eliminate or disconnect the pad on the top
> side. Basically edit the padstack so that for this component there is
> no copper pad on the top layer and no throughhole plating.
>
> How is this done in PSX by the way, I can't seem to figure it out there either?

When the pad is added to the footprint you simply select <topside> or
<bottomside> instead of <through board>.

Leon