Seems to be common to Eagle OSX printing across quite a wide range of printers (several manufacturers), so I doubt it's the driver. Given that OS X prints the PDFs just fine, I don't think it's OS X.
I would raise it with them if it was a significant problem for me, but ...
PG
On 10/01/2010, at 9:41 PM, Andrew Mathison wrote:
> Hi Stefan Trethan
>
> you could be right, but I have a feeling that the problem is from the printer driver. It could also be the printer firmware, so I would recommend checking the internet for updated drivers and firmware.....it may be a combination of both even -old driver, new firmware or the opposite....
>
> If they are still available, even trying older versions may provide a fix....as it is not completely unknown for problems to be added as an update......
>
> If it looks good on the screen, then I would definitely suspect the printer. Another printer from a different manufacturer may provide some helpful infos.....
>
> I did not see a mention as to which version of Eagle is in use.......!!
>
> Best wishes for 2010
>
> Andy
> ----------------------------------------------------------
> Could be an OS X specific problem then?
>
> Best to ask Cadsoft support about it, they reply timely, even if it is
> just a no can do sometimes.
> (Things are gonna stay like they've been, in terms of support, what
> whith Farnell buying them and all.)
>
> ST
>
> On Sat, Jan 9, 2010 at 10:03 PM, Piers Goodhew <piers@...> wrote:
> > Yep, I have seen exactly that with Eagle on OS X (and recall another lister seeing it). Further, I now (under Snow Lep) get super-fat outlines on pads/holes etc (appears fine in Preview, fat on HP 4MP output) so I now copy the file to my 10.3.9 G4 and then print.
> >
> > It's all a hassle, but on a value-for-money basis I still swear by Eagle!
> >
> > PG
> >
> > ------------------------------------
> >
> > Be sure to visit the group home and check for new Links, Files, and Photos:
> > http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
> >
> >
> >
> >
>
> Greetings from
>
> Andy Mathison
>
> [Non-text portions of this message have been removed]
>
>