Hi, Cary,
Welcome to Homebrew_PCBs! Are you planning to make a board for an EDM controller? I keep wanting to update my design and put it on a pcb, but just haven't had time yet.
Speaking of time -- honestly, I think toner transfer would still be easier and quicker than messing with tape, etc. If you were wanting to block a large area, then the tape/contact paper/etc. would be great. But if you are wanting to make traces -- even straight, fat traces -- I think trying to get the tape cut and laid out would be a pain. Meanwhile, toner transfer is really very easy.
The only thing that would be easier than toner transfer would be the Sharpie pen, or similar resist pen -- just draw your traces with a ruler, or freehand if you don't need them to be straight.
Whichever way you decide to go, good luck. Ask back as you have questions!
Andy
--- In Homebrew_PCBs@yahoogroups.com, cary heestand <c.hhestand@...> wrote:
>
> Thank you all for the great replies!
> Â
> Leakage on the edges won't be a problem.
> Â
> I originally was going to use a "ball shaped burr" in a dremel tool and still might go that way. But then thought about using tape and etching.
> Â
> I didn't know you could use a Sharpie on it's own. I thought that was just for repair of toner transfer.
> Â
> Spray paint will work? For what I have to do that might be the way to go. Then I could just remove the paint where the pads are and leave the rest of paint as a solder mask!
> Â
> Again thank you ALL for helping a newbie with my first board. Even if it isn't a complicated one!
> Â
> Cary
> >
> >Be sure to visit the group home and check for new Links, Files, and Photos:
> >http://groups. yahoo.com/ group/Homebrew_ PCBsYahoo! Groups Links
> >
> >
> >
>
>
>
>
>
>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>