I'm just catching up on my email, been in the hospital for 3 weeks.
Another possibility to cover large areas or even use as a resist (cutting out the traces with a knife blade) is "Contac" shelf liner.
Myc
--- In Homebrew_PCBs@yahoogroups.com, cary heestand <c.hhestand@...> wrote:
>
> Thank you all for the great replies!
> Â
> Leakage on the edges won't be a problem.
> Â
> I originally was going to use a "ball shaped burr" in a dremel tool and still might go that way. But then thought about using tape and etching.
> Â
> I didn't know you could use a Sharpie on it's own. I thought that was just for repair of toner transfer.
> Â
> Spray paint will work? For what I have to do that might be the way to go. Then I could just remove the paint where the pads are and leave the rest of paint as a solder mask!
> Â
> Again thank you ALL for helping a newbie with my first board. Even if it isn't a complicated one!
> Â
> Cary
> >
> >Be sure to visit the group home and check for new Links, Files, and Photos:
> >http://groups. yahoo.com/ group/Homebrew_ PCBsYahoo! Groups Links
> >
> >
> >
>
>
>
>
>
>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>