Thank you all for the great replies!
Leakage on the edges won't be a problem.
I originally was going to use a "ball shaped burr" in a dremel tool and still might go that way. But then thought about using tape and etching.
I didn't know you could use a Sharpie on it's own. I thought that was just for repair of toner transfer.
Spray paint will work? For what I have to do that might be the way to go. Then I could just remove the paint where the pads are and leave the rest of paint as a solder mask!
Again thank you ALL for helping a newbie with my first board. Even if it isn't a complicated one!
Cary
>
>Be sure to visit the group home and check for new Links, Files, and Photos:
>http://groups. yahoo.com/ group/Homebrew_ PCBsYahoo! Groups Links
>
>
>
[Non-text portions of this message have been removed]