Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

As you all know I am new to this whole process and therefore have gone to Utube and uncovered many of what seem to be good videos of
pcb manufacturing.

One which I just viewed is different in that the guy is talking about using a paper called 'Press and Peel' and his laser printer
and the rest is the same as normal paper.

This looks like a whole lot faster way of ironing on the toner to the board since you dont have the intermediate steps involved in
removing the messy paper, you still have the quenching but then the paper just peels away without all the time consuming 'finger
rubbing' and tooth brushing steps to remove the paper.

Does anyone have any experience with this type of paper and if so, was it successful or unsuccessful or cost prohibitive?

Thanks,
Bob AD5VJ