Hi Mike,
That 535 laminator has 4 rollers and can go up to 40 feet/min. I have some questions about your process.
1) How long does it take to pass a letter size sheet of paper through lengthwise? My 310 takes 51 seconds.
2) How many passes did the board require through the laminator?
3) Any mods to the laminator?
4) Is the board double sided copper?
5) What temp did your laminator show on the LCD at the time of laminating?
6) Ever measured the roller temperatures?
Thanks!
Mike
--- In Homebrew_PCBs@yahoogroups.com, michael tenore <wb2lcw@...> wrote:
>
>
> Hi!
>
> I scanned one of my recent boards to the Photo section!
> This was done with HP Presentation paper and applied to the Board with a GBC H535 Laminator
> Board is 4.5 x 6.5 inches .062 thick..
>
> http://groups.yahoo.com/group/Homebrew_PCBs/photos/album/1613902738/pic/1067172535/view?picmode=&mode=tn&order=ordinal&start=1&count=20&dir=asc
>
> The board has been etched and drilled but the toner was not stripped off yet..
>
> I will post again when I strip the toner! You can see how nice it came out.
>
> regards
>
> mike..
>