--- In
Homebrew_PCBs@yahoogroups.com, DJ Delorie <dj@...> wrote:
>
>
> "fenris67" <thenephilim10@...> writes:
> > I hear that 135-162 Degrees C is the specific range for toner
> > transfer.
>
> Close enough. I run mine a little hotter.
>
> > I have found a 160 Degree C thermal switch which is physically the
> > same. I assume I need a NC type. Is this change quite as simple as I
> > hope?
>
> Most likely, but you'd have to trace out all the connections to be
> sure.
>
Hi there
I'm pretty sure of the connections so in theory just swapping out the thermal switch will be sufficient. I will have a look and see if there is a hotter switch - maybe 170 C. The only other thought I had is fitting a dimmer switch in the motor line to slow it down so more of the heat is transfered. If that isn't feasable then a PWM relay inline to do the same.
regards
Dave