Thanks Ken and DJ for clearing that up for me. Most of what I do is with
0.062 material, so it sounds like I need to consider other models of
laminators.
Steve K8JQ
sailingto wrote:
> --- In Homebrew_PCBs@yahoogroups.com, DJ Delorie <dj@...> wrote:
>
>> Steve <steve65@...> writes:
>>
>>> In reviewing recent postings, I did not find an answer to this question:
>>> Can this laminator be used for .062in board? Any problems with doing so?
>>>
>> The one I have, basically, no. The rollers in the non-heatseal one
>> are NOT spring loaded and have trouble with 0.062 boards.
>>
>>
>
> DJ, you are correct - the spring on the motor side of my laminator does NOT allow the roller to open up. I just pulled the cover off to check - .062 board does go thru ok, there is a "pop" as the PCB exits the rollers. I suspect the rollers are flexing to allow the thick PCB to go thru.
>
> The spring seems to hold the motor drive engaged with the roller gears - if the level at rear is pressed, the motor moves away from roller gears and the rollers stop. I was thinking I had read the instructions and it said pressing the level allowed the rollers to open.
>
> Sorry about the bad info on rollers being spring loaded. I just ran a small 2"X2" .062 (I just checked with mic) boards thru the rollers just now - seem to roll ok, but with the pop as the board exits. I think the rollers would be damaged with extended use.
>
> 73 de Ken H> K9FV
>
>
>
> ------------------------------------
>
--
Read The Patriot It's Right -- It's Free
http://PatriotPost.US/subscribe/ Veritas vos Liberabit