Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "Daniel Howard Bryant" <coloradobryant@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Tuesday, June 09, 2009 12:26 PM
Subject: [Homebrew_PCBs] Re: DIY conductive vias ?


Your post got me thinking...what if you could make a putty/paste out of a
copper or tin powder? Then squeegee this putty/paste into the holes (or
perhaps inject it with a syringe) where the vias are going to be, then
solder them?.....just tossing out some ideas.


Why not find out what the board manufacturers use to plug vias in pads, and
use that? They, presumably, know what they are doing!

Leon