--- In
Homebrew_PCBs@yahoogroups.com, Steve <steve65@...> wrote:
>
> In reviewing recent postings, I did not find an answer to this question:
> Can this laminator be used for .062in board? Any problems with doing so?
>
> Steve K8JQ
I have ran some .062 boards thru - it does go thru as the rollers are spring loaded and will open up nicely. It sorta "pops" a bit as the boards exits the rollers, but I don't think it will cause any problems... I don't "think" anyway. Hey, it's only $25 shipped so if it does cause problems, post to the group and order another.... The extra pressure didn't seem to "mash" the traces out....
Perhaps Ed will chime in with his experience - he has a LOT more knowledge about laminators than I do....
73 de Ken H> K9FV