Hi Stefan,
I had earlier read ur article on the same and also read the usage of MISPRO
INKS used by u...
I tried a lot to get it here in India but did not succeed in the same.
Cant durabrite used for the same purpose?
Please suggest.
Tamseel.
On Thu, May 28, 2009 at 10:24 PM, Stefan Trethan <stefan_trethan@...>wrote:
>
>
> Good work.
> Try MISPRO yellow ink, it is very tough after curing with the iron and
> probably holds up to the etchant much better.
> <http://www.inksupply.com/arcink_mispro.cfm>
>
> ST
>
> On Thu, May 28, 2009 at 4:50 PM, Tamseel Kotawdekar <aliensole@...<aliensole%40gmail.com>>
> wrote:
> > Dear All,
> > I have a small query.
> > I have successfuly modified an EPSON R310 Printer for Printing onto PCBs.
> > It Prints really beautifully.
> > I m using EPSON Durabrite INKs which are famous for its water-proof
> printing
> > quality.
> > ∗Now my problem is, it does not last until the complete PCB is etched.∗
> > ∗Its resists for some time, I can say for about 5-10 mins and then gets
> > washed off. ∗
> > The Procedure I follow is:
> > 1. Clean PCB with Acetone
> > 2. Strach it with a sand Paper.
> > 3. Print it in Printer.
> > 4. Heat it up with Iron.
> > 5. Put it for etching.
> > I m using ferric chloride for etching PCBs.
> > Also I make sure I put PCB for etching only when INKs are completely dry
> on
> > PCB.
> > Please help
> >
> > --
> > Have A Nice Day
> > (¨`·.·´¨) Always
> > `·.¸(¨`·.·´¨) Keep
> > (¨`·.·´¨)..·´ Smiling!
> > `·.¸.·´
> > --Tamseel--
> >
> >
> > [Non-text portions of this message have been removed]
> >
> >
> >
> > ------------------------------------
> >
> > Be sure to visit the group home and check for new Links, Files, and
> Photos:
> > http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
> >
> >
> >
> >
>
>
--
Have A Nice Day
(¨`·.·´¨) Always
`·.¸(¨`·.·´¨) Keep
(¨`·.·´¨)..·´ Smiling!
`·.¸.·´
--Tamseel--
[Non-text portions of this message have been removed]