Ed is selling ONLY the temperature control module - the laminator he installed it to is a $25 shipped from a vendor on ebay.
I think the laminator is 8.5" wide - I ordered one last week and it is scheduled for delivery today. Sure hope it gets here. I'll be needing a temperature controller also... "IF" this laminator will get hot enough.
Ken H>
--- In Homebrew_PCBs@yahoogroups.com, Andres Hernandez <afhernandez79@...> wrote:
>
> Hi ED
>
> You are saying that you are selling a laminator for dry film applications (fotosensitive) ?.....
>
> If so... what are the maximum dimmentions for a PCB to be laminated ? and if it is for double faced ?.
>
> Because I need at least laminate a PCB of 30 cm wide.
>
> Thanks for your help
>
>
>
>
> ________________________________
> From: Ed Smith <w4eds@...>
> To: Homebrew_PCBs@yahoogroups.com
> Sent: Wednesday, May 27, 2009 9:46:22 PM
> Subject: [Homebrew_PCBs] Laminator Temp Control
>
>
>
>
>
> Hello Guys,
>
> This week I added temp control to my $24.95 GBC laminator using controls left over from my old company. I have several hundred of these in potted module form with thermocouple, control pot, faceplate calibrated for 200F-800F, and instructions. They run on 115VAC and have 5 amp capability.
>
> I will let these go for $20 each and I pay shipping to the lower 48.
>
> Ed Smith
> w4eds@yahoo. com
>
> ============ ========= ========= ========= ========= ========= ==
>
> [Non-text portions of this message have been removed]
>
>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>