I just made a tiny board to play with SMD LEDs (
http://twitpic.com/ 3fiy2 ). Thanks to this thread I just used my handy cheap tinsnips,
and they made pretty short work of the 1/16 fibreglass - the only real
problem was that the cut starts straight, but suddenly veers off when
the "push" from the two sides of the PCB passes some threshold.
But it beats the pants of my previous hacksaw efforts.
PG
On 19/04/2009, at 12:02 PM, Alessio Sangalli wrote:
>
>
> Harvey White wrote:
>
> > If in the US, then Harbor Freight or the equivalent. If outside the
> > US, then I don't know. You might want to look at the local importer
>
> At the end, I have bought a nibbler but I am not satisfied, it is not
> straight enough. I may very well be the problem :) I've never used a
> nibbler before.
>