I would try, first, a cheap homemade setup like this:
http://www.delorie.com/pcb/dremel-stand/(look up for "dremel drill press" or just "dremel" thread in the group posts
Though some users says dremels suffer from a little runout.
Jose
----- Original Message -----
From: "Alessio Sangalli" <alesan@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Saturday, April 18, 2009 10:06 AM
Subject: [Homebrew_PCBs] Drill holes
>I do not plan to do much through-hole (for this reason I am reluctant in
> investing in something pricey/bulky) but I occasionally need to make
> holes.
>
> I have bought some carbide bits at harborfreigh and I have a dremel; on
> the other hand, I've been told those bits can break easily (well I
> think one can break them just by watching them too much, they are so
> small)
>
> What is the recommended solution?
>
> Thank you!
> Alessio
>
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and
> Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>