Well, I meant to say a few 100 pin tqfps, but the results are the
same... I use a cheap laminator to fuse the toner and just soak the
magazine backing off with dishsoap and water, usually peels off
intact after 30 seconds. Rub off some of the paper pulp. I'm
pleased with the results. I don't run into very many instances
anymore that I need to do a home prototype and have to break out the
photo resist stuff. I did a preliminary write up of what I do that's
at the same link --it isn't written very well and some details are
missing, but you can get the jist.
-Dal
--- In Homebrew_PCBs@yahoogroups.com, "rolanyang" <rolan@h...> wrote:
> For small runs, toner transfer is definitely the way to go.
> What is your strategy for separating the paper from the PCB
> after you've ironed? It looks very clean.
> > Pictures
> > http://wheedal.dyndns.org:8255