--- In
Homebrew_PCBs@yahoogroups.com, "Derward Myrick" <wdmyrick@...> wrote:
>
> Stefan, Phill KAoHJBG, Leon and others that were intrested.
>
> On Monday, February 23, 2009 1:21 PM I sent the below message
>
> ----- Original Message -----
> From: Stefan Trethan
> To: Homebrew_PCBs@yahoogroups.com
> Sent: Monday, February 23, 2009 1:21 PM
> Subject: Re: [Homebrew_PCBs] Re: Surface Mount
>
>
> I am using one mil copper.
> Will etch a test board in a couple days and
> put it up for you to see.
>
> Derward
>
> I have been busy and just got around to doing it.
> Go to this site and see it. Note that there are 4
> boards shown. I did more but if I show more boards
> it is hard to se the traces. Also the one labeld five mil
> is the three mill and the one labeled 3 mill is the 5 mill.
> http://www.denhamsprings.com/pcb_1mil.jpg
>
> Derward Myrick KD5WWI
The 3 mil and 5 mil tracks look about the same, and the 1 mil track looks about 2/3 the width of the others.
Leon