Stefan, Phill KAoHJBG, Leon and others that were intrested.
On Monday, February 23, 2009 1:21 PM I sent the below message
----- Original Message -----
From: Stefan Trethan
To: Homebrew_PCBs@yahoogroups.com
Sent: Monday, February 23, 2009 1:21 PM
Subject: Re: [Homebrew_PCBs] Re: Surface Mount
I am using one mil copper.
Will etch a test board in a couple days and
put it up for you to see.
Derward
I have been busy and just got around to doing it.
Go to this site and see it. Note that there are 4
boards shown. I did more but if I show more boards
it is hard to se the traces. Also the one labeld five mil
is the three mill and the one labeled 3 mill is the 5 mill.
http://www.denhamsprings.com/pcb_1mil.jpg
Derward Myrick KD5WWI
[Non-text portions of this message have been removed]