Have you checked the Links under "Plated Through Holes" yet? Not many
links there, but it is something. Markus Zingg's page on through hole
plating has been down for a while, but I just found where someone
mirrored it and put that link in place of the missing site.
http://tech.groups.yahoo.com/group/Homebrew_PCBs/linksIf you find any other links on through-hole plating, please place them
there.
Steve Greenfield
--- In Homebrew_PCBs@yahoogroups.com, "Juan EA7FNJ" <esp7xx@...> wrote:
>
> Hi guys!
>
> I'd like to make the vias of my board and I think the best method is
> electroplating. But, I was looking for some information about it, and
> I didn't find something that I can understand.
>
> My question:
>
> How can I make a good vias using electroplating? I was reading and I
> have some ideas: clean the copper side of my PCB, use an acid bath,...
>
> But I don't know how many volts and amps to make it, concentrations...
>
> is there any good manual step-by-step?
>
> Thanks.
>