How many do you need and how large are the pieces that you need?
I am in the SE MI area, but they are easy to ship
I can trim them to size, within reason.
73
Kurt WU8V
-----Original Message-----
From:
Homebrew_PCBs@yahoogroups.com [mailto:
Homebrew_PCBs@yahoogroups.com]On
Behalf Of Henry Liu
Sent: Thursday, October 16, 2008 12:37 PM
To: homebrew_pcbs
Subject: [Homebrew_PCBs] cutting homebrew pcbs and source of cheap blanks?
Can someone suggest a source of cheap pcb blanks?
Also, how do you cut your pcbs from a bigger piece? I can mill the
outline out but it is not an easy process because I usually hold it in
a vice. If I send a 1/32 end mill through it then it starts to flop
around in the middle and I don't get a clean cut unless I think of a
better clamping method. Maybe a vertical band saw would work best but
I'm wondering what you guys use out there. A small chop saw seems
like it would work too.
Thanks.
Henry
No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 270.8.1/1728 - Release Date: 10/16/2008
7:38 AM
[Non-text portions of this message have been removed]