Hello all,
If you have a table saw and a plywood blade that works good. I use some thin scrap plywood under the board and cut that at the same time. Any scrap wood would work to support board while cutting.
--
Loren Moline
WA7SKT
-------------- Original message ----------------------
From: "Henry Liu" <
henryjliu@...>
> Can someone suggest a source of cheap pcb blanks?
>
> Also, how do you cut your pcbs from a bigger piece? I can mill the
> outline out but it is not an easy process because I usually hold it in
> a vice. If I send a 1/32 end mill through it then it starts to flop
> around in the middle and I don't get a clean cut unless I think of a
> better clamping method. Maybe a vertical band saw would work best but
> I'm wondering what you guys use out there. A small chop saw seems
> like it would work too.
>
> Thanks.
> Henry
[Non-text portions of this message have been removed]