Go on eBay there is a guy selling FR4 cheap and he will cut it for you!
----- Original Message ----
From: Henry Liu <
henryjliu@...>
To: homebrew_pcbs <
homebrew_pcbs@yahoogroups.com>
Sent: Thursday, October 16, 2008 4:37:17 PM
Subject: [Homebrew_PCBs] cutting homebrew pcbs and source of cheap blanks?
Can someone suggest a source of cheap pcb blanks?
Also, how do you cut your pcbs from a bigger piece? I can mill the
outline out but it is not an easy process because I usually hold it in
a vice. If I send a 1/32 end mill through it then it starts to flop
around in the middle and I don't get a clean cut unless I think of a
better clamping method. Maybe a vertical band saw would work best but
I'm wondering what you guys use out there. A small chop saw seems
like it would work too.
Thanks.
Henry
[Non-text portions of this message have been removed]