Ed,
Add a little automatic dishwasher detergent to the soaking bath. The
alkalinity and wetting agents help dissolve the residue. Then use a
toothbrush to lightly scrub the pcb.
Myc
On Sun, Oct 12, 2008 at 6:00 PM, Ed Smith <w4eds@...> wrote:
>
>
> Hi All,
>
> I am making a small SMT 1"X3/4" board with 10 mil lines and spaces. Using a
> Samsung 1430 printer and HP PhotoGloss laser paper.
>
> The transfer looks great with no flow of toner. However, I can not get all
> of the paper removed from the 10 mil spaces. It is even more difficult , of
> course, to remove it from the traces.
>
> What to do ?? Different paper, more/less heat, more/less time, expecting
> too much ??
>
> Thanks,
>
> Ed Smith Spencer, VA
> w4eds@... <w4eds%40yahoo.com>
>
> =================================================================
>
> [Non-text portions of this message have been removed]
>
>
>
[Non-text portions of this message have been removed]