DJ Delorie <
dj@...> writes:
> I added the results of a 5/5 etch to my inket page:
>
> http://www.delorie.com/pcb/inkjet/
I added a photo of the finished board. I watched the etch more
carefully this time. As it got nearer to "done", I'd take it out,
rinse and dry it, and put it under the microscope to see how it was
doing. Thus, I was able to get a near-ideal etch time, as well as
adjust the position in the tank to try to even out the overall etch.
I did manage to mangle one of the vias, but then again, those are 13
mil holes with only 6 mil annulus, and I got two out of three ;-)