Your system is getting better and better!
I am curious though why the comb pattern is only on one side. Did you
figure out why?
Bertho
=========================================
From: DJ Delorie Sent: Friday, July 04, 2008 16:32
I added the results of a 5/5 etch to my inket page:
http://www.delorie.com/pcb/inkjet/I decided to be cautious this time. As soon as the big blank spots
started vanishing, I stopped the etch, rinsed the board, and inspected
the smallest traces under a microscope. They were etched! They
looked unetched with the magnifier. Took only 25 minutes for 1/2oz
copper.
Based on these results, I now know to reduce my inked edges by about a
mil to get the copper dimensions to match the design, as the copper
was about 2 mil thinner than planned. I'm guessing the comb pattern
on the edges from the inkjet (which happen to be about a mil wide :)
cuts the UV down too much to get a full cure. Might also be causing