A few days ago, I read on HP website that they are using a special mean to fuse the toner with the transparent so no possible release .
--- On Fri, 7/4/08, DJ Delorie <dj@...> wrote:
From: DJ Delorie <dj@...>
Subject: Re: [Homebrew_PCBs] double sided PCB, accuracy
To: Homebrew_PCBs@yahoogroups.com
Date: Friday, July 4, 2008, 5:49 PM
Try using laser transparencies instead of inkjet transparencies
(assuming the toner will release afterwards).
The pin trick is easier if you pre-poke the holes from the toner side,
so you can tell where they are.
[Non-text portions of this message have been removed]