Harvey White <
madyn@...> writes:
> Has anyone considered aligning the masks with a filler made from a
> scrap piece of etched board, same thickness, and then perhaps a
> piece of plastic to duplicate the board?
Another thing to try is to tape ∗three∗ corners, not two. The extra
tension helps hold the seam centered on the thickness of the board.
Not that I've ever done that; my TT paper is too opaque to line up
that way. I've pre-drilled target holes in the PCB and poked matching
holes in the TT paper to tack it down in the right place, with some
success.