--- Brian Pitt <
bfp@...> wrote:
> > instead of transfers from laser printer to copper.
> > how about just buying a thin copper sheet say 3mil
> or so.
> > then run the copper through the laser printer and
> print your art work.
>
> just tested this and it dosent work so well
>
> I used 'Slug & Snail' tape its an adhesive backed
> copper foil
> sold in the garden dept at some stores (Seattle
> area)
> placed a small strip on a sheet of regular paper and
> ran a
> test page on an HP laserjet 1200 (nice printer for
> toner transfers BTW)
>
> got some of the letters,but many dropouts and the
> toner lifted off onto
> the rolls and re-deposited itself further down the
> page (smear)
> a second test page without the tape came
> out clean and sharp ,so no damage done :-)
Very brave, foolish, or got an old cheap laser
printer. ;')
Foreseeable, I suppose, as the fuser roller is only
sized to heat up at most a thick sheet of paper, and
paper has very little heat capacity so it doesn't take
much to heat it to 400F. Copper, on the other hand,
takes a lot to heat up. Think about how long you have
to hold the iron or heat press on the board, and some
recommend preheating the board. I can only send thin
boards through my non-modified laminator.
I suspect my friend's laser printer directly on PCB
worked because it was very old and likely overpowered.
Steve Greenfield
__________________________________________________
Do You Yahoo!?
Send your FREE holiday greetings online!
http://greetings.yahoo.com