That's a neat idea too.
Instead of spray etching why not "rinse etch".
ST
On Tue, Apr 29, 2008 at 12:41 AM, drpain1313 <yahoo@...> wrote:
> Many years ago (10? 15?) when I used to do a lot more board building,
> I had bought a low-cost etch tank that used a pump to move the etchant
> over a ramp of sorts, where the pcb was placed. It worked quite well
> as I remember. I suppose this would be called a wave etch tank. I
> tried to search for this type of tank with no luck. Does someone
> still make these?
>
> Also, someone asked about the laminated copper foil I sell. The
> website is http://www.laserpcb.com