Very rewarding work. Are the boards through hole plated or
just plated on the outside ? I only ask because I wasn't
sure if you have the electroless up and running.
From what i've gathered, electroless copper processing is
by far the most troublesome. If you get that understood,
then everything else is a little easier. Since you are
paying good money for these chemicals, then you should
expect good support from the suppliers.
Will your process use panel plating method for producing
through hole PCBs ? If so what photoresist will you be using
to seal the holes from the copper etchant ? Normally they
are "tented" across with dry film negative resist.
Adam
Markus Zingg wrote:
> Hi folks!
>
> I'm a happy man! See the pictures of the first sucessfully through
> hole plated PCB on the page!
>