Actually, yes.
I used some 600 grit wet/dry sandpaper to clean the board after I'd already
used a brillo soap pad, then rubbed down the board with rubbing alcohol. I
also humidified the Pulsar paper prior to running it through the laser
printer.
The smaller board was noticeably hotter to handle.
Chuck
WB2EDV
----- Original Message -----
From: "Myc Holmes" <mycroft2152y@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Monday, February 11, 2008 10:41 PM
Subject: Re: [Homebrew_PCBs] Transfer looking good now
> Did you make any other changes besides the size of the board and the
> number
> of passes?
>
> TANSTAAFL!
>
> Myc
>
> On Feb 11, 2008 9:00 PM, Chuck Kelsey <wb2edv@...> wrote:
>
>> Well, I think I may have done it.
>>
>> First, I made my boards smaller so that they wouldn't sink as much heat.
>> Instead of a 4" x 6" board with 6 circuits on it, it is now 1/3 that
>> size.
>>
>> I ran it through 16 times.
>>
>> No traces came off.
>>
>> Chuck
>> WB2EDV
>>
>>
>>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> Be sure to visit the group home and check for new Links, Files, and
> Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
> Yahoo! Groups Links
>
>
>
>