On 14 Jan 2008, at 18:51, peripherin wrote:
> The good thing about the laminator is that it does not need any
> modification to the rollers to take the 1.6mm board. Shame that it is
> not able to melt the toner.
Use the laminator to tack your master to the PCB, may be best to pass
it through corner first; do it a couple of times from opposite corners.
Use your iron to heat the laminate and master, resting the sandwich on
a folded newspaper, a folded piece of kitchen paper, your sandwich,
and another folded piece of kitchen paper. No need to move the iron,
let it rest on top for about a minute.
Now take your by now very hot PCB and pass it through your laminator a
few times. How many will depend on experience.
Works for me (assuming that the iron is big enough to heat the whole
PCB at once).
<lengthy off-topic quoted message deleted>
--
Cheers
Derryck