"Jim Miller" <
jim@...> writes:
> I've gotten some breakout boards in the past from Sparkfun that
> worked well for SOIC but I now need a few for a uSOIC which has
> 0.5mm lead pitch for 10 pins (or more.)
These are the types of boards I'm most likely to make at home. Just
design one, put four to six copies on a small panel, and etch them.
Choose the best resulting board. I use resistor lead trimmings for
"legs" (they're smaller than 0.025" sq posts).
0.5mm pitch is only 10 mil rules, you should be able to do that at
home.