2007/3/26, wnnelson0 <wnnelson@...>:
>
> I modded a C88 without hacking the frame. I made new bushings for
the
> drive shaft which lowered it by .100".
I'm trying to understand what I see in those pictures. Are the new
bushings to the far left and right of the picture with the originals
in the center?
How did you make those? Did you mill or turn them from plastic stock?
> I trimmed off the outfeed
> rollers to give a flat carrier path and moved the paper sensor to
the
> front. This allows a carrier with no cutout notch for the timing.
I'm confused by "trimmed off" and don't understand what you mean. Did
you remove them?
> I put
> > a smaller gear on the end of the drive shaft for the vacuum pump
> > because there was no room for the original gear.
Where did you get the gear? Junk box? Did you measure it? Any chance
we could know what sort of gear to order?