"Jeffrey Jenkins" <
tesseract@...> writes:
> H210), can supposedly lay down tracks and pads tighter than 8/8 design
> rule reliably. Does anyone here have any experience to confirm or
> refute this?
I have the whole Pulsar kit (GBC Creative), and I can do 6.7/6.7 (four
pixels on my laser printer) with a little care. 0.5mm pitch SMT parts
(9.8mil rules) are not a problem, 0.4mm pitch (7.8mil rules) works
too.
0.4mm pitch and 01005 parts on pulsar-type board:
http://www.delorie.com/pcb/smd-challenge/old/proto-boards.htmlclose-up of 01005 cap next to an 0.4mm pitch IC:
http://www.delorie.com/pcb/first.html