>
>
>
>
>
>
>
> > The Super Fine pens seem to plot about a .015" wide trace which
> > severly restricts layouts (relative to what I have been doing so far).
> >
> > I went for the Staedtler pens based on SO MANY recomendations here
> > from SO MANY people as to how well it holds up to etching. Aside from
> > putting the ink on the copper, has anyone had to do any other special
> > treatments (heating, drying, etc.) before performing the etching
> > process?
> >
The best hold up to etch I have found is the uniball paint pen, I have
only tried the px203 white, its tip is fine but thats not fine by our
standards, but for standard DIP layouts its a superb pen.
I'm still trying to find a friendly driver for dip trace, I currenty
export it as BMP, then edge detect it, then load that into a vinyl
cutting package, takes longer than designing the boards lol