John P. Anhalt wrote:
> The insulation on the wire I use is heat sensitive. I run the tip of my soldering iron along one side. That essentially removes a small strip of insulation. The insulation can then be peeled back from the wire as far back as the strip and clipped off in the usual manner. The wire I use is from RadioShack and unfortunately the actual manufacturer is not listed for it. John
>
>
If you are using Radio Shack's 30-gauge wrapping wire, then just get
their wire wrapping tool:
http://www.radioshack.com/product/index.jsp?productId=2103243It comes with a wire stripper that strips this wire perfectly. But only
a strip-mall RadioShack will carry this tool.
Cheers,
Bryan