>Not saying you should. I am saying my
>bubble etcher is bad and I need to get a
>new etcher. You obviously have a better
>bubble etcher than I do.
Check out messages 14958 and 14969. I've always favored the smallest BE
(ET-10) mainly because 6"X4" is my standard board size and you need
half as much etchant to handle that in an ET-10 than the larger BEs.
But as message 14969 indicates, all ET-20s are not the same so it's
quite possible that all ET-10s are not the same either. Whatever, I've
never had any of the issues usually attributed to BEs.
--- In Homebrew_PCBs@yahoogroups.com, "Andrew" <andrewm1973@...> wrote:
>