Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "Ronald Ausloos" <ronald_ausloos@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Friday, March 23, 2007 5:27 AM
Subject: Re: [Homebrew_PCBs] Velleman PCB Etching Tank ET-20


> Didn't you have any problems to fix that heating element in the tank? Here
> in Belgium , the heater is supplied with 2 big suckers. They even don't
> fit in that tank! So , I had to fix the heater with some rope .... Time to
> etch a pcb is the same like yours.

The heater hangs straight down in mine, the top assembly with the thermostat
control is a bit wider than the tank.

The suckers must be for an aquarium. I broke one of mine pushing it onto the
heater, I should have slid it on from the end. I don't need them, anyway.

Leon