Why not stick with an older rebuilt unit like a laserjet 4000? 18 ppm and
1200 dpi. I have one rebuilt and nearly new that I will be selling soon for
about $200 plus ship. Has 2 250 sheet trays. It's a 4000TN but no jetdirect
but can install one if needed for extra. Ship weight about 50 lbs. Has 9300
or so pages total, about 50 since new fuser and rollers (maint kit). It
won't be till late next week as I'll be gone out of area.
-----Original Message-----
From:
Homebrew_PCBs@yahoogroups.com[mailto:
Homebrew_PCBs@yahoogroups.com]On Behalf Of Gary Hoyles
Sent: Thursday, February 08, 2007 5:06 PM
To:
Homebrew_PCBs@yahoogroups.com Subject: [Homebrew_PCBs] New Laser Priner suggestion
I'm about to get a new laser printer as the last one popped due to power
lines falling down here in high winds a few weeks ago and put 450 Volts into
mains system.
As i will be using this for toner transfer does anybody have a suggestions
as to what would be good. I was looking at the HP laser jet 1022 as its 1200
dpi, Don't really want to spend to much as i have a lot of other bits to
replace too.
Oh, and i now swear by UPS power supplies with Surge protection, as my PC
survived!
Gary
----- Original Message ----
From: William Nelson <
wnnelson@...>
To:
Homebrew_PCBs@yahoogroups.com Sent: Thursday, February 8, 2007 5:54:17 PM
Subject: Re: [Homebrew_PCBs] Epson Stylus Photo 900 direct inkjet printing
I like the idea of the flat nozzle, I just run the small perhaps .5in
round nozzle around until I
push the print button. OK so now a temp sensor that starts the print on
reaching the correct temp.
Oh boy something else to make. I don't know if all the "C" models are the
same (seems so) but it
doesn't start printing right away each time. Sometimes there is a big
delay before print, other
times its immediate. This means I have to keep the heat on and wait.
__________________________________________________________
Any questions? Get answers on any topic at www.Answers.yahoo.com. Try it
now.
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]