Hey Russ,
If you were married, you would understand.
:)
Myc
--- In Homebrew_PCBs@yahoogroups.com, Russell Shaw <rjshaw@...> wrote:
>
> Gary Hoyles wrote:
> > Look, this in a good excuse t get a new printer, I don't want to
got replacing anythin!!!! Shurrrrrrrrsh
>
> Well considering this is a group for cheapskates (otherwise you'd
just pay the money
> to get someone to make your boards), paying $200 for a new printer
goes against the grain;)
>
> > ----- Original Message ----
> > From: Russell Shaw <rjshaw@...>
> > To: Homebrew_PCBs@yahoogroups.com
> > Sent: Friday, February 9, 2007 2:00:46 AM
> > Subject: Re: [Homebrew_PCBs] New Laser Priner suggestion
> >
> > Gary Hoyles wrote:
> >> I'm about to get a new laser printer as the last one popped due
to power lines falling down here in high winds a few weeks ago and
put 450 Volts into mains system.
> >
> > Replace the fuse in it. If it still blows, replace the main
electrolytic
> > and/or switch-mode regulator transistor.
> >
> >> As i will be using this for toner transfer does anybody have a
suggestions as to what would be good. I was looking at the HP laser
jet 1022 as its 1200 dpi, Don't really want to spend to much as i
have a lot of other bits to replace too.
> >>
> >> Oh, and i now swear by UPS power supplies with Surge protection,
as my PC survived!
>