On Sat, 03 Feb 2007 22:30:59 +0100, William Nelson
<
wnnelson@...> wrote:
> Yes almost the same. I made a flat feeder path with outside rails that
> feed the PCB holder. No
> cutting of the feeder bar required. I lifted mine up .125 in and lifted
> the top pressure rollers
> also. I can feed the full width of the printer 8.5 inches plus and the
> full length also. I dont
> think I'll ever make a board that big but you never know. I also put the
> paper sensor in the same
> place. I will post some pics.
How did you treat the pressure rollers?
I have not yet found an ideal solution. I just cut them apart so i got a
single roller on each end of the width. But i could not feed a PCB with
the full width, the rollers would not lift that much. It is not a problem
for printing on paper, and i don't think i will need a pcb that wide, but
if you have a good solution...
What did you use as carrier (material)?
ST