On Mon, 29 Jan 2007 22:43:03 +0100, Volkan Sahin <
vsahin@...>
wrote:
> Hi Stefan,
> It is most probably because of the printer that I am
> using. It does not apply so much ink.
> Volkan
Oh i can apply less ink with the C84 too, but if i use a lower setting it
will not resist.
Only when i use the highest setting so that there is a puddle of ink it
will resist after curing.
This is fine for wider traces if the board is prepared well, but can not
make fine traces becasue the puddles link up.
You must make something differently. Could also be curing. I have
postponed all experiments until i have enough time, and can finish the
oven so i can make a proper test series.
ST