The upside is better current capability, have had plated holes burn through
on some analog boards.
-----Original Message-----
From:
Homebrew_PCBs@yahoogroups.com[mailto:
Homebrew_PCBs@yahoogroups.com]On Behalf Of David McNab
Sent: Tuesday, January 02, 2007 7:21 PM
To:
Homebrew_PCBs@yahoogroups.com Subject: Re: [Homebrew_PCBs] Through Hole Plating Alternative
On Tue, 2007-01-02 at 22:06 +0000, Paul Sturpe wrote:
> What is the best (read most fool proof) way for a neophyte PCB
> builder
> to get continuity through the holes on a double sided board?
The best, cheapest and most reliable way I can think of is the obvious
method, needing no extra equipment or expense: stick wires through each
of your vias and solder them on each side. The main downside is the
addition of extra per-board labour.
Cheers
David
[Non-text portions of this message have been removed]