Be VERY careful with the router. Mine yanked the board out of my hand and scared the heck out of me.
I'm not doing that again. I didn't have a large enough board to hold on to.
----- Original Message -----
From: DJ Delorie
To: Homebrew_PCBs@yahoogroups.com
Sent: Wednesday, December 13, 2006 4:43 PM
Subject: Re: [Homebrew_PCBs] Re: Wooden CNC router
I have a standard X-Acto paper cutter that works (barely) for 0.031"
FR4.
Normally, I use #2 scroll saw blades on 0.062, which are good for
about a foot or two before they need to be replaced. Fortunately,
they're cheap. Next time I'm at the store, though, I'm going to pick
up a v-scoring bit and see how that works out on my router table.
[Non-text portions of this message have been removed]