>> does anybody have/use a wooden CNC router (DIY) with a Dremel for
punching
>> holes into a PCB?
>> repeatability - accuracy - over all precision?
>> is the Dremel run-out good enough for 20 mil (0.5 mm) bits? or what's the
>> minimum non breaking size?
You can see some of the results I get with a dremel tool CNC router:
http://www.probotix.com/pcb_milling_and_routing My mill was built for less money than one of those wooden routers using
high-end components found off of eBay. I spent about $300 on precision
linear slides.
You will find pics of my CNC router here:
http://www.probotix.com/prototype_desktop_cnc_mill I use PCB-GCODE to convert my Eagle files to g-code. I can easily cut 16 mil
traces.
>Len
[Non-text portions of this message have been removed]