I have to laugh! They start of by saying "Please consider the following as an
open minded statement that...",
then later state "...isolation milling is a slow, expensive, almost 30 years
old attempt to be different by someone who had a paranoia against chemical
etching".
Whether true or false, it's opinionated and obviously written in a tone that
screams desperation to not lose support for their products/methods. They
also state things, but don't explain why.
Yes, they're comparing PCB milling machines here and not specifically
thru-hole activation, but I think that machines like LPKF would be great for
other uses -- like they can engrave front panels for electronic projects,
etc.
As for thru-hole plating, whenever I solder a component lead in a plated hole,
the solder always wicks itself thru the hole and over to the other side. For
flexible wires, I purposely add more solder so it builds up on the opposite
side, so I get a better mechanical hold. My guess is that even if there is
resistance with the "conductive paste" method, the solder will fill the gaps
and conduct properly. Of course, this is my thought/guess, as I've never
done this before.
I'm going to ignore that whole article as ∗desperate∗ marketing hype.
-Neil.
On Saturday 10 May 2003 11:53, Stefan Trethan scribbled:
> hmm the guys from bungard don't like this.
> they say it has too high resistance.
>
> http://www.bungard.com/downloads/ANTI_E.PDF
> somewhere in there...
>
> regards
> st
>
> 10.05.2003 18:30:02, Neil <cobra_neil@...> wrote:
> >Here's one system/source for chemical thru-hole plating that I've had
> > laying around in my bookmarks....
> > http://www.thinktink.com/stack/volumes/volvi/condink.htm
> >
> >(I've never experimented with this though).
> >
> >Cheers,
> >-Neil.
> >
> >On Friday 09 May 2003 19:29, JanRwl@... scribbled:
> >> Markus!
> >>
> >> Please let us know what those "right chemicals" are, and how to apply
> >> them! (Temperature? catalysts? time in bath? USW!)
> >>
> >> Then, what current (Strom, Amperes) per 0.1 m^2 to plate-through!
> >>
> >> But remember! The plating-through is done BEFORE etching!
> >>
> >> Thanks! Jan Rowland
> >
> >Be sure to visit the group home and check for new Bookmarks and files:
> >http://groups.yahoo.com/group/Homebrew_PCBs
> >
> >To unsubscribe from this group, send an email to:
> >Homebrew_PCBs-unsubscribe@yahoogroups.com
> >
> >
> >
> >Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
> ---
> [This E-mail scanned for viruses]